Introduction of Parameters and Installation of ZP Automatic Exhaust Valves
First, technical parameters of ZP automatic exhaust valves
1. medium: clean water
2. Temperature: normal temperature
3. Shell strength test pressure: 1.5MPa, no damage.
4. Floating ball sealing test pressure: 0.05∽1.1MPa without water leakage
5. Valve body material: gray cast iron HT200/ brass/stainless steel
6. Nominal pressure: 1.0-1.6MPa
7. Product specification: DN15-DN200
8. Connection mode: screw thread/flange
Second, the installation introduction:
If the ZP automatic exhaust valve is installed vertically, it should be installed at the top of the project; if it is installed horizontally, it should be installed at the end. If the internal screws of this series of products are installed well, gas can be discharged smoothly. If the product has unexpected situations such as air leakage, water leakage and impurity blockage during the project operation, it needs to be cleaned in time, and it can run normally after being installed again.
Maximum working temperature (water): 120℃.
1. medium: clean water
2. Temperature: normal temperature
3. Shell strength test pressure: 1.5MPa, no damage.
4. Floating ball sealing test pressure: 0.05∽1.1MPa without water leakage
5. Valve body material: gray cast iron HT200/ brass/stainless steel
6. Nominal pressure: 1.0-1.6MPa
7. Product specification: DN15-DN200
8. Connection mode: screw thread/flange
Second, the installation introduction:
If the ZP automatic exhaust valve is installed vertically, it should be installed at the top of the project; if it is installed horizontally, it should be installed at the end. If the internal screws of this series of products are installed well, gas can be discharged smoothly. If the product has unexpected situations such as air leakage, water leakage and impurity blockage during the project operation, it needs to be cleaned in time, and it can run normally after being installed again.
Maximum working temperature (water): 120℃.
